No products were found matching your selection.
Other Related Products
-
- Material: PET base film
- Finish: clear, matte, or ultra-matte
- Surface Function: anti-smudge and easy-clean
- Thickness: customizable by end use
- Adhesive: silicone, acrylic, OCA, or non-tacky
- Supply Form: jumbo roll, slit roll, or sheet
-
The COF of PET film describes resistance when a defined surface starts and continues sliding against another surface. This reference applies to uncoated, coated, treated and PET-based protective film used in unwinding, slitting, laminating and die cutting. Each result must be read with its tested sides, method, load and conditioning history. Equipment compatibility, adhesive behavior and removal performance still require sample testing on the actual material and process.
-
- Material: PE protective film
- Common thickness: 30–100 microns
- Standard colors: clear, blue, black & white
- Adhesion level: low to medium tack
- Typical widths: 200–1600 mm
- Main use: temporary appliance surface protection
-
- Material: Biaxially oriented PET
- Color: Natural clear
- Thickness: Typical reference 12-250 um
- Formats: Master rolls, slit rolls, cut sheets
- Surface: Untreated or basic treated options
- Uses: Printing, lamination, packaging, graphics
-
- Roll Widths: 300–1,400 mm (custom to 1,350mm)
- Roll Length: Adjustable, typically 200–400 m
- MOQ: As low as 100 kg (≈500 kg for certain grades)
Customizable Enhancements:
- Anti-scratch or anti-fog coatings
- UV stabilization or conductive/ESD treatment
- Surface corona for improved printability
-
Conventional PET and BOPET films commonly show a polyester film melting temperature of about 245-260 C by DSC. The reported onset, peak, or endset varies with grade, orientation, thermal history, and scan conditions. Use it for base-film identification, not as a finished-film service limit. Confirm adhesive, coating, surface, dwell, and removal behavior under intended conditions.
-
- Material: Fluoro-silicone coated PET film
- Color: Clear, milky white, or customized tone
- Thickness: 50μm, 75μm, 100μm, custom thickness available
- Release side: Single-side or differential release
- Adhesive match: Silicone PSA, silicone tape, soft medical gel adhesive
- Key function: Clean release with controlled peel force
-
Plastic film for appliance touch controls is used to protect appearance-sensitive interfaces while glass, printed overlays, display windows, decorative panels, and surrounding housings move through manufacturing. The challenge is not simply preventing scratches. A film can introduce a new problem if its adhesion is mismatched, contamination is trapped beneath it, an edge lifts near a cutout, or the temporary layer changes a capacitive touch check. This solution focuses on surface identification, controlled application, sample validation, film-on versus film-off functional checks, planned removal, and failure diagnosis before full production use.
-
- Material: Polyethylene (PE) protective film
- Thickness: 30–100 microns (custom available)
- Adhesion: Low to medium tack, surface-adjustable
- Color: Transparent, blue, black/white, custom colors
- Width: 50mm–1200mm (custom slitting supported)
- Length: 50m–2000m (jumbo roll supply available)
