No products were found matching your selection.
Other Related Products
-
- Material: Optical-grade PET with single-side ITO coating
- Color: Clear with a slight blue-gray tint
- PET thickness: 125, 175, or 200 um
- Sheet resistance: 10, 60, 100, 200, or 300 ohm/sq
- Supply form: Rolls, sheets, slit rolls, or converted parts
- Main uses: Touch electrodes, transparent heating, and EMI/RFI shielding
-
- Material: PET polyester film
- Color options: clear, matte, white, black, or custom
- Common thickness: approx. 25–250 microns
- Supply format: die cut pieces, kiss-cut sheets, or roll form
- Adhesive option: single-sided, double-sided, or non-adhesive
- Liner option: paper liner, film liner, or differential release liner
-
- Material: Polyethylene (PE) protective film
- Thickness: 30–100 microns (custom available)
- Adhesion: Low to medium tack, surface-adjustable
- Color: Transparent, blue, black/white, custom colors
- Width: 50mm–1200mm (custom slitting supported)
- Length: 50m–2000m (jumbo roll supply available)
-
- Material: PE or PET protective film
- Color: clear or translucent
- Adhesive type: removable PSA
- Surface focus: overlays and display windows
- Process fit: printing, die cutting, lamination
- Main purpose: temporary surface protection
-
- Material: PET film with siliconized release surface
- Thickness: 25 / 36 / 50 / 75 / 100 micron
- Color: Clear, milky white, blue tint or customized
- Release Type: Single-side, double-side or differential release
- Roll Form: Jumbo roll or slit roll
- Main Uses: Labels, tapes, die-cut parts, PSA lamination
-
The COF of PET film describes resistance when a defined surface starts and continues sliding against another surface. This reference applies to uncoated, coated, treated and PET-based protective film used in unwinding, slitting, laminating and die cutting. Each result must be read with its tested sides, method, load and conditioning history. Equipment compatibility, adhesive behavior and removal performance still require sample testing on the actual material and process.
-
Conventional PET and BOPET films commonly show a polyester film melting temperature of about 245-260 C by DSC. The reported onset, peak, or endset varies with grade, orientation, thermal history, and scan conditions. Use it for base-film identification, not as a finished-film service limit. Confirm adhesive, coating, surface, dwell, and removal behavior under intended conditions.
-
- Material: PE or PET protective film
- Color: clear, translucent, black & white
- Thickness: 50–100 microns typical
- Adhesive: water-based acrylic or acrylic PSA
- Width: custom slit rolls and sheet formats
- Use stage: fabrication, transport, installation, renovation
-
A plastic film specified for electronics shipping should be approved against the actual contact surface, the role it plays in the ESD packaging system, and the condition expected at final removal. This guide applies to display modules, touch panels, HMI assemblies, printed overlays, coated housings, and other finished electronic products exposed to handling, storage, road, air, or sea transport. The main risks are scratching, trapped contamination, edge lift, film movement, charge generation, adhesive transfer, haze, coating disturbance, and difficult removal after extended dwell. Approval should therefore combine surface identification, packaging review, staged sample testing, transport simulation, and post-removal inspection rather than relying on one datasheet value.
